Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
WARNING
Service
WARNING
cause a serious hazard. All tool service should be performed by a SKIL Factory Service
Center or Authorized SKIL Service Station.
General Maintenance
WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
Cleaning
WARNING
ventilation slots clean.
Always use only a soft, dry cloth to clean your nailer; never use detergent or alcohol.
Cleaning the Nail Channel
(Fig . 10)
WARNING
away from you while cleaning the nail channel.
NOTICE: Clean the nail channel regularly.
Failure to properly and regularly clean the
channel will cause premature failure or void the
warranty.
a. Remove the battery pack from the tool.
b. Press the magazine release button to open
the magazine, and then remove the nails
from the magazine.
c. Lift the jam release latch and open the jam
release.
d. Use a small amount of pneumatic tool oil on a clean cloth or cotton swab to wipe down the
nail channel.
e. Reload the nails and close the magazine.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.
18
To avoid serious personal injury, always remove the battery pack
from the light when cleaning or performing any maintenance.
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
When servicing, use only identical replacement parts . Use of any
other parts could create a hazard or cause product damage.
Before cleaning or performing any maintenance, remove the battery pack
from the tool. For safe and proper operation, always keep the tool and its
Remove the battery pack
and keep the tool pointed
Fig. 10
Nail
Channel
Jam
Release
Jam
Release
Latch
Publicidad
