Brixton KO-6383DU Manual De Usuario página 6

Tap markings
liGhtinG your stove
liGhtinG instructions:
• Turn the gas tap control knobs clockwise to "OFF" position.
• Connect the regulator to the gas bottle. Turn the gas supply "ON" at
the cylinder. Check with the use of soapy water for any gas leakage
between the bottle and the regulator and the appliance connection
• Open the lid fully before lighting the burners. Turn one of the control
knobs turning anti-clockwise to the large flame symbol position, full
rate position whilst holding a match to the burner to be lit, this will light
the burner. If the burner does not light, repeat this process.
• If the burner has not lit after two attempts, turn off the gas tap, wait
5 minutes and then repeat step 3.
• When the burner is lit. The remaining burners may now be lit by
following instructions 3 and 4 above precisely.
• The taps can be adjusted to a low rate position marked with a small
flame symbol or any rate between full and low rate.
• To turn the stove 'OFF' turn the cylinder valve or regulator switch to the
'OFF' position and then turn all of the control knobs on the appliance
clockwise to the 'OFF' position when the flame have extinguished.
• Warning: If the burner fails to ignite, turn the control knob off
(clockwise) and also turn the cylinder valve off before attempting to
relight with ignition sequence.
6
• Before cooking for the first time, operate the stove for about 15 minutes
with the gas turned on HIGH. This will "heat clean" the burners.
• Clean your stove after each USE. DO NOT use abrasive or flammable
cleaners, as it will damage the parts of the product. Clean in warm
soapy water.
WarninG: Accessible parts may be very hot. Keep young children away
from the hot appliance at all times (even while cooling down!).
cleaninG and care
caution: All cleaning and maintenance should be carried out when the
stove is cool and with the gas supply turned OFF at the gas cylinder.
cleaninG
outside surface
Use mild detergent or baking soda and hot water solution. Non-abrasive
scouring powder can be used on stubborn stains, then rinse with water.
cookinG Grid
Use a mild soapy water solution. Non-abrasive scouring powder can be
used on stubborn stains then rinse with water.
cleaninG the burner assembly
• Turn the gas OFF at the control knob and disconnect the cylinder.
• Remove pan support.
• Clean the burner with a soft brush or blow clean with compressed air
and wipe with a cloth.
• Clean any clogged ports with a pipe cleaner or stiff wire (such as an
opened paper clip).