Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly and Installation (continued)
Installing a single deck light (with or without the
3
hardscape adaptor) on concrete, brick, or other non-
wood surface
Deck light with hardscape adaptor:
Place the hardscape adaptor (C) on the surface where you want it to be
□
installed, and choose which two holes on the hardscape adaptor (C)
best align with the installation location. Mark the location of the 2 holes,
and remove the hardscape adaptor (C) from the surface.
At those marks, use a 7/32 in. drill bit to drill two 30 mm deep holes on
□
the mounting surface.
Push the plastic anchors (BB) into the two holes until the heads of the
□
plastic anchors (BB) are flush with the mounting surface.
Place the hardscape adaptor (C) on the surface, and secure it by
□
screwing the two self-threading screws (AA) into the plastic anchors
(BB).
Insert the male plug (B) into the female plug (E).
□
Proceed to Step 5 or 6 if installing multiple lights, or Step 8.
□
Deck light without hardscape adaptor:
Place the deck light (A) on the surface where you want it to be installed,
□
and mark the location of the 2 holes on the deck light (A). Remove the
deck light (A) from the surface.
At those marks, use a 7/32 in. drill bit to drill two 30 mm deep holes on
□
the mounting surface.
Push the plastic anchors (BB) into the two holes until the heads of the
□
plastic anchors (BB) are flush with the mounting surface.
Place the deck light (A) on the surface, and secure it by screwing the
□
two self-threading screws (AA) into the plastic anchors (BB).
Insert the male plug (B) into the female plug (E).
□
Proceed to Step 5 or 6 if installing multiple lights, or Step 8.
□
Installing a single deck light (with the hardscape
4
adaptor) on a wood surface
Place the hardscape adaptor (C) on the mounting surface and
□
choose which two holes on the hardscape adaptor (C) best align
with the installation location.
Use a Phillips screwdriver to screw the self-threading screws
□
(AA) through the two best holes on the landscape adapter (C) to
secure it onto the mounting surface.
Insert the male plug (B) into the female plug (E).
□
Proceed to Step 5 or 6 if installing multiple lights, or Step 8.
□
2
Publicidad
