Braun Serie 5 5197cc Manual De Instrucciones página 17

• Next, switch off the shaver, press the release button (2) to remove the Foil & Cutter
cassette (1) and let it dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil on top of the Foil & Cutter cassette.
The shaver should be cleaned after each foam usage.
Cleaning with a brush
Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat
surface. Using the brush, clean the inner area of the pivoting head. Do not clean the
cassette with the brush as this may damage it!
Clean&Charge Station (C&C)
The Clean&Charge Station has been developed for cleaning, charging, lubricating,
disinfecting, drying and storing your Braun shaver.
13 Station power socket
14 Lift button for cartridge exchange
15 Station-to-shaver contacts
16 Clean&Charge Station display
16a Level indicator
16b Status light
16c Cleaning program indicators
17 Start button
18 Cleaning cartridge
Installing the C&C
• Remove the protection foil from the C&C display.
• Press the lift button (14) at the rear side of the C&C to lift up the housing.
• Hold the cleaning cartridge (18) down on a flat, stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge from the rear side into the base of the station until it snaps into place.
• Slowly close the housing by pushing it down until it locks.
• Using the special cord set (10), connect the station power socket (13) to an electrical
outlet.
Using the C&C
Important: The shaver needs to be dry and free from any foam or soap residue!
Insert the shaver in the C&C upside down, with the front showing and released head
lock (3).
The contacts (7) on the back of the shaver need to align with the contacts (15) in the
C&C. Push the shaver in the correct position. A beep sound confirms that the shaver
sits properly in the C&C.
17