FUXTEC FX-KS226 Manual De Instrucciones página 69

MODE D´EMPLOI ORIGINAL FUXTEC FX-KS226_de_en_fr_ita_rev02
12. Transport and storage
69
Chain stay
• Turn the chain stay over from time to
time to prevent one-sided wear.
• The guide groove of the chain stay must
always be at right angles, so check the groove
for wear from time to time.
Place a ruler against the chain stay and the
outside of a saw tooth. If there is a gap
between the ruler and the chain stay, the guide
groove is in order. If there is no clearance, the
guide is worn out. In this case the chain stay
must be turned over or replaced.
(1) Ruler (2) Distance (3) No distance (4) Chain
runs crooked
- During transport and when changing
location during work, the chainsaw must be
switched off and the chain brake must be
released to prevent the chain from starting up
accidentally.
- Never carry and transport the chainsaw
with the saw chain running!
- When transport/storage over a longer
distance, the supplied rail guard must be fitted
in any case.
- Only carry the chainsaw by its handle.
The saw-bar points to the rear after the saw.
Do not come into contact with the muffler (risk
of burns).
- Store the chainsaw safe in a dry area.
The saw must not be stored outdoors. Do not
make the chainsaw accessible to children.
- When storing and shipping the chainsaw
for a longer period of time, the fuel and oil tank
must be completely empty.
In vehicles: Secure the device against tipping
over, damage and fuel leakage.