Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC SHREDDING OPERATION
16Ms: Continuous operation:
20Ms: Continuous operation:
Up to 20-minutes maximum
Up to 30-minutes maximum
NOTE: Shredder runs briefly after
NOTE: Shredder runs briefly after
each pass to clear entry. Continuous
each pass to clear entry. Continuous
operation beyond 20-minutes will
operation beyond 30-minutes will
trigger 15-minute cool down period.
trigger 10-minute cool down period.
ADVANCED PRODUCT FEATURES
SAFESENSE
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
Turn the shredder
Touch test area and
ON ( ) to activate
look for the SafeSense
SafeSense
indicator to illuminate
®
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
All micro-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
*Apply oil across entry
Press and hold forward ( )
2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain
illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and
recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. Close the bin to resume shredding.
Remove Paper: When illuminated, press reverse (
SafeSense
Indicator: If hands are too close to the paper entry, the SafeSense
®
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
PAPER OR
1
Plug in and put
disconnect power
switch in ON (I) position
SafeSense
®
Technology
Stops shredding immediately when
hands touch the paper entry.
TECHNOLOGY OPERATION
®
3
4
SafeSense
is active and
If hand is held on SafeSense
®
working properly
area more than 3 seconds,
®
shredder will shut off
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
CARD
2
Press ON ( ) to
activate (white)
Auto Reverse
Stops and reverses paper if a
jam occurs.
®
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
2
1
Turn off and unplug
Locate Auto-start
shredder
infrared sensor
indicator will illuminate and the shredder will stop shredding. If SafeSense
®
3
4
Feed paper/card
When finished
straight into paper
shredding set
entry and release
to OFF ( )
.
3
Dip cotton swab in
rubbing alcohol
®
4
Using cotton swab, wipe
away any contamination
from the paper sensors
3
Publicidad
