Aerian COSY1800 Manual De Instrucciones página 10

TROUBLESHOOTING
PROBLEM
No warm air is coming
from the heater.
The appliance turns
off and will not turn
back on.
The appliance does
not turn on when the
switch is pushed to
"ON".
Flame is dim or not
present.
SPECIFICATIONS
Ra ngs: 220-240V~ 50-60Hz
1800W
POSSIBLE CAUSE
1.The overheat protec on
device in the appliance has been
triggered.
2.The thermostat knob may be
adjusted at a too low posi on.
1. The overheat protec on
device in the appliance has been
triggered.
2. House circuit breaker has
been tripped.
The overheat protec on device in
the appliance has been triggered.
1. Light bulb is burnt out.
2. "Flame wand" has come loose
from bracket.
3. "Flame wand" motor is not
func oning.
EN7
SOLUTION
1. Turn all controls off, unplug the
appliance, and allow to cool for at
least 10 min before plugging back in
and restar ng.
2. Rotate the thermostat knob
clockwise to the "MAX" posi on.
1. Turn all controls off, unplug the
appliance, and allow to cool for at
least 10 min before plugging back in
and restar ng.
2. Reset house circuit breaker.
Turn all controls off, unplug the
appliance, and allow to cool for at
least 10 min before plugging back in
and restar ng.
1. Inspect light bulb and replace if
necessary. (See the sec on Replacing
the light bulb of this manual.)
2. Please contact a professional
technician to do the following.
Remove screws holding back access
panel in place and remove back
access panel .Secure end of "flame
wand" back into the support bracket.