Publicidad
Idiomas disponibles
Idiomas disponibles
16. Disconnect Tools
Before servicing; when changing
accessories such as blades, bits, cut-
ters, etc.
17. To Reduce The Risk Of Accidental
Starting
Make sure switch is in "OFF" position
before plugging in. Turn switch "OFF"
in the event of a power failure.
18. Use Recommended Accessories
Consult the owner's manual for rec-
ommended accessories. Follow the
instructions
that
accessories. The use of improper
accessories may cause hazards.
19. Never Stand On Tool
Serious injury could occur if the tool is
tipped or if the cutting tool is acciden-
tally contacted.
Do not store material above or near
the tool such that it is necessary to
stand on the tool to reach them.
accompany
the
3
20. Check Damaged Parts
Before further use of the tool, a guard
or other part that is damaged should
be carefully checked to ensure that it
will operate properly and perform its
intended function. Check for align-
ment of moving parts, binding of mov-
ing
parts,
mounting, and any other conditions
that may affect its operation. A guard
or other part that is damaged should
be properly repaired or replaced. If
power cord is worn or cut, or dam-
aged in any way, have it replaced
immediately.
21. Direction Of Feed
Feed work into a blade or cutter
against the direction of rotation of the
blade or cutter only.
22. Never Leave Tool Running Unat-
tended.
Turn power off. Don't leave tool until it
comes to a complete stop.
breakage
of
parts,
Publicidad
