Publicidad
Note:
An audio message tells you which mode
you have selected. Refer to the table below.
Audio message
RADIO
BLUETOOTH
FM radio mode
In FM radio mode you get access to FM radio.
To change FM radio station
•
Push and hold the volume up button or the volume
down button for 1 second to change FM radio
station.
®
Bluetooth
mode
®
In Bluetooth
mode you can connect your product to a
®
device with Bluetooth
wireless technology.
®
To do a Bluetooth
1. Push and hold the Bluetooth
to start the pairing operation on your product.
Note:
The pairing operation starts when you hear
a beep sound and the Bluetooth
blue. The pairing operation is on for 30 seconds.
2. Start the pairing operation for Bluetooth
technology on the device.
3. If it is necessary, select Husqvarna X-COM Active in
the list of units on your device.
Note:
An audio message tells you about the
product status. Refer to the table below.
Audio message
LED indicator on
the Bluetooth
button
BLUETOOTH
Solid blue.
DEVICE CON-
NECTED
BLUETOOTH
Solid red for 2
CONNECTION
seconds.
FAILED
Note:
A device with Bluetooth
that is connected to your product, connects
10
pairing operation
®
button for 2 seconds
®
button flashes
®
wireless
Information
®
The product is
connected to a
device with Blue-
®
tooth
wireless
technology.
The product is
not connected to
a device with
Bluetooth
less technology.
®
wireless technology
automatically to your product the next time the product is
used with the device.
To set up a team and add devices
A team is a communication group that lets you speak to
all the devices that are connected to the team. If there
is no team and you do this procedure, you set up a new
team. Then you can do the procedure again to add new
devices to the team. Only one person sets up a team
and the other devices connect to the team as shown in
To connect to a team on page 11 . Only one person at a
time can add a new device to the team. The new device
must connect to the team as shown in
team on page 11 .
1. Push the mode button for 1 second to enter the team
management mode to enter team setup.
Note:
team management mode. Refer to the table below.
Audio message
TEAM MANAGEMENT
2. Push the Bluetooth
Note:
operation status. The pairing operation starts when
you hear a beep sound. Refer to the table below.
Audio message
SEARCHING FOR
MEMBERS
Note:
The devices connects to the team in approximately 1
minute. The pairing operation is completed when you
hear a beep sound and the Bluetooth
a constant green light. A beep sound is heard each
time a new device connects to the team. To connect
to a team, refer to
11 .
3. If you want to stop the pairing operation in less than
1 minute, push the mode button.
4. If you want to add a new device to the team, follow
the same instructions again.
®
wire-
Note:
A device that is connected to the team,
connects automatically to the team next time you use
it.
An audio message tells you that you are in
LED indicator on the
Bluetooth
Solid white.
®
button.
An audio message tells you the pairing
LED indicator on the
Bluetooth
LED flashes quickly.
The pairing operation is on for 1 minute.
To connect to a team on page
1957 - 002 - 09.10.2023
To connect to a
®
button
®
button
®
button shows
Publicidad
