Descargar Imprimir esta página

Gessi 20699 Instrucciones De Instalación página 2

Ocultar thumbs Ver también para 20699:

Publicidad

PRELIMINARI - PRE-INSTALLATION INFORMATION - PRÉALABLES - VORBEREITUNG -
PRELIMINARES - ПРЕДВАРИТЕЛЬНАЯ ПОДГОТОВКА - ΠΡΟΕΡΓΑΣΙΕΣ - 引言
Dimensioni in mm - Measures in mm - Dimensions en mm - Maß im mm - Medidas en milímetros - Размеры выражены в мм - Διαστάσεις σε mm - 尺寸以毫米为单位
ART. 20699
Prima dell'installazione e messa in funzione
Attenzione! I tubi d'alimentazione devono essere sciacquati con cura prima dell'installazione del dispositivo, in
modo che non rimangano trucioli, residui di saldatura o canapa, o altre impurità all'interno dei tubi. Attraverso
tubazioni non sciacquate a fondo o attraverso la rete idrica generale, nel dispositivo possono entrare corpi
estranei in grado di danneggiare guarnizioni/o-ring. Si raccomanda pertanto di dotare anche l'impianto generale
di filtri.
DATI TECNICI
- Pressione massima d'esercizio 5 bar
- Pressione d'esercizio consigliata 3 bar (in caso di pressione dell'acqua superiore ai 5 bar si consiglia
l'installazione di riduttori di pressione)
Before installation and setting to work
Attention! The feeding pipes have to be rinsed carefully before the installation of the device so that there won't
remain shavings, sealing or hemp residues, or other impurities inside the pipes. Through pipes not thoroughly
rinsed or through the general water network, in the device foreign bodies can enter that could damage gaskets
/o-ring. So filters should be installed also on the general system.
TECHNICAL DATA
- Maximum working pressure 5 bar
- Recommended working pressure 3 bar (in case of water pressure higher than 5 bar it is recommended to install
pressure reducers)
Avant l'installation et la mise en fonction
Attention! Les tuyaux d'alimentation doivent être rincés avec soin avant l'installation du dispositif, de sorte que
ils ne restent pas de copeaux, des restes de soudage ou de chanvre, ou d'autres impuretés à l'intérieur des
tuyaux. A travers les conduites non rincées à fond ou à travers le réseau hydrique général, dans le dispositif
peuvent entrer des corps étrangers à même de détériorer les gaines/o-ring.On recommande ainsi d'installer des
filtres également sur le système général.
DONNÉES TECHNIQUES
2

Publicidad

loading