Publicidad
Idiomas disponibles
Idiomas disponibles
Before performing any type of maintenance/service, disengage all controls
and stop the engine. Wait until all moving parts have come to a complete
stop. Disconnect spark plug wire and ground it against the engine to
prevent unintended starting.
Interval
Each Use
1.
2.
3.
4.
First month or five hours
1.
Annually or 25 hours
1.
2.
Annually or 50 hours
1.
2.
3.
Every 200 hours
1.
2.
Before Storage
1.
† In dusty conditions or when airborne debris is present, clean more often.
†† Change every 25 hours when used under heavy load or in high ambient temperatures.
Always stop engine, allow engine to cool, disconnect spark plug wire, and
ground against engine before performing any type of maintenance on your
machine.
General Recommendations
•
Always observe safety rules when performing any maintenance.
•
The warranty on this lawn mower does not cover items that have been
subjected to operator abuse or negligence. To receive full value from
warranty, operator must maintain the equipment as instructed here.
•
Changing of engine-governed speed will void engine warranty.
•
All adjustments should be checked at least once each season.
•
Periodically check all fasteners and make sure these are tight.
Lubrication
Blade Control
1.
Lubricate pivot points on the blade and drive control at least once a season
with light oil. These controls must operate freely in both directions.
See Figure 17.
SERVICE AND MAINTENANCE
MAINTENANCE SCHEDULE
WARNING
Item
Engine oil level
Loose or missing hardware
Air cleaner
Unit and engine
Engine oil
Air cleaner †
Control linkages/pivots and wheels
Engine Oil ††
Spark plug
Air Cleaner
Spark plug
Air cleaner
Fuel system
WARNING
Follow the maintenance schedule given below. This chart describes service
guidelines only. Use the Service Log column to keep track of completed
maintenance tasks. To locate the nearest Sears Service Center or to schedule service,
call the following toll free number:1-888-331-4569.
See the Engine Operator's manual packed with the mower for detailed instructions
on how to perform many of the following maintenance items.
Service
1.
Check
2.
Tighten or replace
3.
Check
4.
Clean
1.
Change
1.
Clean
2.
Lube with light oil
1.
Change
2.
Check. Adjust if necessary.
3.
Check
1.
Change
2.
Change
1.
Run engine until it stops from lack of fuel, or
add stabilizer to a full tank of fresh fuel prior
to storage.
2.
The transmission is pre-lubricated and sealed at the factory and does not
require lubrication.
3.
Follow the accompanying engine manual for lubrication schedule and
instruction for engine lubrication.
16
Service Log
Figure 17
Publicidad
