MAGIC REMOTE FUNCTIONS
Magic remote battery is low. Change the battery.
When the message
replace the battery. To install batteries, open the battery cover, replace batteries
(1.5 V AA) matching
the battery cover. Failure to match the correct polarities of the battery may cause
the battery to burst or leak, resulting in fire, personal injury, or ambient pollution. Be
sure to point the remote control at the remote control sensor on the TV. To remove
the batteries, perform the installation actions in reverse.
CAUTION
Do not mix old and new batteries, as this may damage the remote control.
y
y
This remote uses infrared light. When in use, it should be pointed in the direction of the TV's remote
sensor.
Press the center of the Wheel button to
You can change channels by using the
Returns to the previous screen.
Switches among broadcast (antenna)
and various inputs.
These access special functions in some
(
Red,
Green,
Adjusts the volume level.
Displays the Screen Remote.
* Accesses the Universal Control Menu
* Pressing and holding the
will display a menu to select an external
device that is connected to the TV.
Used for viewing 3D video.
Mutes all sounds.
Scrolls through the saved channels.
and
ends to the label inside the compartment, and close
Wheel (OK)
select a menu.
Wheel button.
(BACK)
(EXIT to LIVE)
Color buttons
menus.
Yellow,
Blue)
VOL
VOL
/INPUT
in some regions.
button
(MUTE)
CH
MAGIC REMOTE FUNCTIONS
is displayed,
(POWER)
Turns the TV on or off.
(up/down/left/right)
Press the up, down, left or right button
to scroll the menu.
If you press
the pointer is in use, the pointer will
disappear from the screen and Magic
Remote will operate like a general
remote control.
To display the pointer on the screen
again, shake Magic Remote to the left
and right.
(Home)
Accesses the Home menu.
/INPUT
CH
(Voice recognition)
Network connection is required to use
the voice recognition function.
1. Press the voice recognition button.
2. Speak when the voice display
window appears on the left of the TV
screen.
* Use the Magic remote no further than
10 cm from your face.
* The voice recognition may fail when
you speak too fast or too slowly.
* The recognition rate may vary
depending upon the user's
characteristics (voice, pronunciation,
intonation, and speed) and the
environment (noise and TV volume).
P
31
Navigation buttons
buttons while