wow! MEGA SLIDE Manual Del Propietário página 4

C O N N E C T M U L T I P L E W O W M E G A S L I D E S T O G E T H E R W H E N Y O U B U Y 2 O R M O R E S L I D E S
1. If you are connecting more than one slide together make sure the slides are connected properly using the
pontoon side wall locking connection system found on the end of the pontoons. After both slides are layed out
in the recommended area and properly inflated now you can lock the pontoons together. Please reference
the diagram below to see how to lock the pontoons together. Insert the rectangle shape male end into the
female end fitting and then push down to lock the pontoons in place.
2. Then make sure the end of the first slide's floor is overlapped on top of the next slide's floor.
The overlap should almost extend to the start graphic on the front of the second slide.
3. Check all side wall pontoon anchor straps and pins so they are secure and the pins are
properly in the ground.
4. Spray both slides with water before connecting the hose.
5. If you have a second hose connect this to the sprinkler system fitting found on the second slide.
BUY 2 OR MORE SLIDES!
EZ CONNECTION SYSTEM
G I A N T
6
W O W M E G A S L I D E A F T E R - U S E W A R N I N G S & I N S T R U C T I O N S :
• When done using the WOW MEGA SLIDE shut the water hose off.
• Disconnect the water hose.
• Deflate the side wall pontoons by opening up the large valves completely.
• Deflate the Mega Sleds by opening up the valves and squeezing the
air out by pinching the base of the valve.
• Remove the anchor pin stakes from the ground and let
the slide completely dry.
• Do not use the WOW MEGA SLIDE while its drying.
• Fold up the WOW MEGA SLIDE to fit your tamper proof storage container properly.
• Only store the WOW MEGA SLIDE after its completely dry in a tamper proof storage container
away from children to avoid danger of suffocation.
MAINTENANCE:
• You may clean your product using soap and water or mild detergent.
• Never use strong cleaning agents.
• The product, when clean and dry, can be deflated and stored in a cool, dry area out of direct sunlight.
• To deflate, simply unfasten the entire valve from the base. Note to unfasten all valves if you have
multiple valves on your product .
• Avoid storing this product in areas of extreme temperatures and please take precautions against animals
and rodents.
PRODUCT STORAGE:
To prepare the product for storage please make sure that it is completely dry to prevent
mildew and rot. Release all of the air from the chamber(s) and fold the product. If possible please store these
products in a controlled temperature and do not expose the product to temperatures less than 40 degrees F.
Cold temperature will damage the PVC material and cause it to crack at the folds.
7