Adjusting the headrest in the
carry cot
The angle of the headrest in the carry cot can be ad-
justed. To do this, place the metal rods in the fixtures
provided for this purpose (Fig. 21).
Canopy and carrying handle
carry cot/sports seat
The attachments are equipped with a hood including
a peephole, which also serves as a carrying handle.
Carrying the tops with the child is not permitted. To
adjust the canopy of the baby tub to the desired posi-
tion, press the round buttons located on the sides (Fig.
22, 23, 26).
Attention. Put the canopy in place before lifting the car-
ry cot by the carrying handle. The carrying handle is
only suitable for carrying the carry cot, not the whole
stroller.
Assembly and disassembly of the
sport seat
The procedure for assembling and disassembling the
seat is the same as for the carry cot - see Assembling
and disassembling the carry cot (Fig. 24, 25). The seat
can be mounted both against and in the direction of
travel.
Adjusting the footrest on the
sport seat
The stroller has an adjustable footrest. To adjust this to
the desired position. Press the push buttons on both
sides of the support (Fig. 27, 28). In addition, the foot-
rest can be extended. To do this, lift the upper part up-
wards and then pull it towards you.
Assembly and disassembly of the
safety bar
The seat is equipped with a safety bar. To install it,
push the plastic pins into the openings of the armrests
(Fig. 29). To remove it, press the pushbuttons located
on both sides of the plastic pins and pull out the safety
bar.
Attention. Always use the seat with the
safety bar.
Safety harness
The sport seat is equipped with a 5-point safety har-
ness (Fig. 30). This must always be used. Release the
straps by pulling the tongues out of the central buck-
le, place your child in the stroller and adjust the strap
lengths so that they fit the child's body but are not too
tight. Then press the tongues of all straps into the cen-
tral buckle.
21
23
25
27
29
22
24
26
28
30