Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Item NO: S200A; Materials: Aluminium; Wheel: 2*200mm PU
•
Slide the handlebar stem over the threaded locking section
•
Ensure the arrow on the fork is facing forward and the handlebars sweep
backwards
•
Tighten the bolts evenly and tightly using the Allen key provided
•
Make sure the wheels face forward when the handlebars are held facing
straight
NOTE:
•
A bolt that seems fully tightened may require further turning after tightening
the other two bolts
•
Make sure you read and follow all the warnings and instructions written in this
manual before using the scooter
•
You might risk serious injury from collisions, falls or loss of control if you fail to
read, follow or understand all the basic operational instructions and warnings
stated in this manual
•
It is your duty to check as well as obey all the laws and regulations, in your region
•
It is advice to keep your fingers and toes away from all the moving parts of the
scooter
•
Do not touch the braking mechanism after braking, as it will get hot from continu-
ous use
6
ASSEMBLY:
WARNING:
Publicidad
