koban KDP1 360FP BK Manual Del Usuario página 31

Close up two spring clips of detector
and insert detector into the drilled
hole on ceiling tightly (See FIG.11).
=65
FIG.11
Restore power supply.
Flush mount with European standard
junction box
terminals and spring clip are not
needed to be used when the
detector is flush mounted with
European standard junction box.
Take off detector's two spring clips
with tool before installation.
FIG.12
Pull out cables from European
standard junction box (See FIG.13),
then strip off 6 - 8mm of cable
sheathing for wiring (See FIG.5-FIG.7)
Power cable
Spring clips
Turn the decorative frame of detector
anti-clockwise with proper strength,
then insert two screws into the
knock-outs on top cover and screw
the detector on European standard
junction box (See FIG.14).
Cover up the decorative frame and
restore power supply.
KDP1 360FP BK
6 - 8mm
FIG.13
FIG.14
31