• The electrical and magnetic fields emitted by this heat pad may inter-
fere with the function of a pacemaker. However, they are still well
below the limits: electrical field strength: max. 5000 V/m, magnetic
field strength: max. 80 A/m, magnetic flux density: max. 0.1 millite-
sla. Please therefore consult your doctor and the manufacturer of
your pacemaker before using this heat pad.
• Do not pull, twist or make sharp bends in the cables.
• If the cable and control of the heat pad are not positioned properly,
there may be a risk of becoming entangled in, being strangled by,
tripping over, or stepping on the cable and controller. The user must
ensure that excess lengths of cable, and cables in general, are safely
routed.
• Please check this heat pad frequently for signs of wear and tear
or damage. If any such signs are evident, if the heat pad has been
used incorrectly or if it no longer heats up, it must be checked by the
manufacturer before being switched on again.
• Under no circumstances should you open or repair the heat pad
(including the accessories) yourself because faultless functionality
can no longer be guaranteed thereafter. Failure to observe this will
invalidate the guarantee.
• If the mains connection cable of this heat pad is damaged, it must be
disposed of. If it cannot be removed, the heat pad must be disposed
of.
• When this heat pad is switched on:
– Do not place any sharp objects on it
– Do not place any heat sources, such as hot water bottles, heat
pads or similar, on it
• The electronic components in the control warm up when the heat
pad is in use. For this reason, the control must never be covered or
placed on the heat pad when it is in use.
• It is essential to observe the information relating to the following
chapters: Operation, Cleaning and maintenance, Storage.
• If you should have any questions about using our devices, please
contact our Customer Services department.
3. Intended use
CAUTION
• This heat pad is only designed to warm up the human body.
• To avoid damage to the film cover and/or the insulation of the cables, do not use the heat pad in
conjunction with essential oils or lotions.
12