Publicidad
Idiomas disponibles
Idiomas disponibles
Replicating the settings - CLONE BOX
The Clone Box (separately purchased) replicates the settings of the master TV into other TVs.
POWER
MUTE
RECALL
CH
ASPECT
ACTION
VOL
VOL
CH
SAP
R-TUNE
TV/VIDEO
INPUT
To check the settings uploaded into the Clone Box
1. Insert a slender tool about 3/4 inch (ex. a paper clip) into
[AMS] hole on the Clone Box to switch the TV to the normal
TV mode.
The green LED lights for approx. 2 seconds.
2. Press [TEST] button on the Clone Box.
• The red and green LED flash alternately during checking.
• The green LED lights for approx. 2 seconds when the settings
replicated in the Clone Box correspond to the master TV settings.
If the red LED does not light, upload the settings again.
Selecting the master TV settings
1
Select the settings of the master TV (see pages 9-12).
You can replicate the following settings.
Menu
Submenu
PICTURE
PIC MODE
COLOR
TINT
BRIGHTNESS
PICTURE
SHARPNESS
COLOR TEMP
2
Press [ CH
, CH
channel you would like to display at power ON (ex. self-advertising
channel).
3
Press [ VOL
, VOL
maximum volume in the HOTEL mode (see page 14).
Uploading the master TV's settings into the Clone Box (LEARN)
Be sure to set the TV to the normal TV mode before uploading. If not in the normal TV
mode, change the mode referring to "Switching between the normal TV mode and the
HOTEL mode" (see page 14).
Preparation
• Connect the master TV display to the AC outlet.
• Connect the Clone Box to the MATE terminal on the tuner board.
1
Turn the master TV display on.
2
Turn the Clone Box on.
The red and green LEDs on the Clone Box flash.
3
Hold down [ALT] button and press [LEARN] button on the Clone Box.
• The red LED flashes during uploading.
• The green LED lights for approx. 2 seconds when uploading is completed.
• After uploading, the master will be automatically switched into the HOTEL mode.
4
Turn the main power of the display and the Clone Box off.
Menu
AUDIO
CHANNELS
SET UP
] or the numbered buttons to select the initial
] to select the volume level which will be the
To check the Clone Box's battery
1. Turn the Clone Box on.
2. Hold down [ALT] button and press [TEST]
button on the Clone Box.
• The red and green LEDs flash alternately during
checking.
• The green LED lights for approx. 2 seconds when
the battery has enough remaining power. If the
LEDs do not light, replace the battery to new one
(use a 9-volt battery).
Submenu
BASS
TREBLE
PRESET CAPTION
MANUAL CAPTION
INPUT LABEL
AUTO PROGRAM
MANUAL PROGRAM
ENERGY MGMT
13
Publicidad
