iTools ITR52E Manual De Instrucciones página 39

Storage in case of longer stopping periods
Never store the machine with petrol in the tank inside a
building. Petrol vapors may come into contact with
flames or sparks and explode.
Store the machine in a dry area with the fuel tank empty
and the fuel in a well-ventilated compartment. Avoid
places with high humidity to avoid the appearance of
corrosion and rust.
Clean the machine thoroughly before storage,
especially in winter. Keep the device in a good operating
mode.
Make sure the device is protected against unauthorized
use (for example, by children).
Technical assistance
Your equipment must only be repaired by the brand's
technical service or qualified professionals and only
with original spare parts.
ASSEMBLY INSTRUCTIONS
Handle assembly
1. Lift the cover of the handlebar support;
2. Unscrew the screw completely with the supplied hex
key;
3. Remove the upper handlebar support and place the
handlebar in the concavity of the lower handlebar
support;
4. Do the opposite process to fix the handlebar;
Blade guard assembly
The blade guard avoids the projection of loose objects
and accidental contact with the user.
The blade guard should always be assembled
when using the nylon line. It should be removed
when using the grass blade.
1. Attach the blade/guard to the axis and tighten with
two screws;
2. Insert the blade guard into the groove;
3. Then press it into position with the claws;
4. The guard is easily removed using a screwdriver.
The blade guard does not protect the user against
all objects (stones, glass, wire, etc) that are
designed by the cutting accessory. These objects can
bounce off any surface and hit the user.
39
Cutting blade assembly
Check the state of the blade before assembling it to the
power tool. If it is damaged (cracked, folded or broken)
replace it.
1. Place the upper fixing plate on the output shaft;
2. Turn the blade spindle until the hole in the upper
clamping plate is aligned with the corresponding hole in
the top of the protective cover;
3. Insert the locking pin into the hole to lock the shaft;
4. Place the blade, lower fixing plate and base of the
protective cover on the output shaft;
5. To tighten the nut, turn the key in the opposite
direction of rotation.
6. Remove the locking pin after complete installation.
Cutting head with nylon line assembly
1. Place the upper fixing plate on the output shaft;
2. Turn the blade spindle until the hole in the upper
fixing plate is aligned with the corresponding hole in the
upper protective cover;
3. Insert the locking pin in the hole to lock the shaft;
4. Screw into the cutting head in the opposite direction
to the direction of rotation;
Placing the nylon line on the cutting head
1. Press the fixing tabs and remove the cutting head
cover;
2. Remove the reel from the cutting head and remove
the line;
3. Prepare about 5m of nylon line and fold it in half;
4. Fix the line in the groove of the central spacer of the
reel, in the position of the fold;
5. Roll both extremities in parallel, one in each side of
the central spacer, clockwise (arrow shown on the reel);
6. Attach the ends of the line to the outer fixing grooves
of the reel;
7. Insert the reel into the cutting head cover;
8. Release the line from the fixing grooves and insert the
ends of the line into the grooves of the cover;
9. Place the cutting head cover;