Initial Setup - Makita WUT02 Manual De Instrucciones

INITIAL SETUP

Installing the wireless unit
NOTE: The wireless unit is supplied as an optional
accessory in some countries.
NOTICE:
For the precautions for handling the
wireless unit, refer to the instruction manual of
the tool to be used with this adaptor.
Install the wireless units into the adaptor and tool as
illustrated. When inserting the wireless unit, align the
projections with the recessed portions on the slot.
1
2
5
2
► 1. Adaptor 2. Lid 3. Wireless unit 4. Projection
5. Recessed portion
4
3
3
2
4 ENGLISH
To remove the wireless unit, open the lid slowly. The
hooks on the back of the lid will lift the wireless unit as
you pull up the lid.
2
1
► 1. Wireless unit 2. Hook 3. Lid
After removing the wireless unit, keep it in the supplied
case or a static-free container.
NOTICE:
Always use the hooks on the back of
the lid when removing the wireless unit. If the
hooks do not catch the wireless unit, close the lid
completely and open it slowly again.
Installing the adaptor
NOTICE:
Do not insert the adaptor's plug into
the outlet of other appliances than the outlet of
the vacuum cleaner for auto start/stop function.
Make sure that the stand-by switch on the vacuum
cleaner is set to "O (OFF)".
Plug the vacuum cleaner's power cord into the mains and
then plug the adaptor's cord into the cleaner's outlet.
3