Empyre Gamma + HC-RM062 Manual Del Usuario página 13

ATTENTION! Depending on the selected speed, the battery life may differ.
USEFUL TIPS FOR CUTTING
• Wash the hair as usual, dry and brush it in the direction of growth to untangle
any knots.
• After drying, do not use hairspray, mousse or gel.
• Start at the highest setting of the supplied guide comb (12 mm) and gradually reduce
the setting of the hair length using the other guide combs supplied (9-6-3 mm).
• For best results, use the appliance against the direction of hair growth.
• If hair starts to clog the guide comb, remove the guide comb from the appliance
(see par. "Removing the guide comb") and clean away the hair (blow and/or
brush out).
USING THE APPLIANCE
Use of the cutting guide comb
To insert the guide comb (fig. A2) follow the instructions below:
• Check that the appliance is off.
• Slide the guide comb onto the head until you hear it click into place (Fig. C).
• Ensure that the guide comb is correctly inserted in the slots on either side.
• Turn on the appliance as indicated in par. "Turning the appliance on and off".
• Cut the hair; for tips see par. "Useful tips for cutting".
Turn off the appliance before changing or inserting any accessories.
Removing the guide comb
• Turn off the appliance.
• Push the guide comb so that it slides off the appliance (Fig. C1).
Using without the guide comb.
When using the appliance without the guide comb, the blade of the
head (2) will cut the hair very close to the skin.
The appliance can be used without the guide comb to cut hair very close to the skin
(0.5 mm) or to redefine the hairline of the neck and around the ears.
If the appliance has been used with the guide comb and is then to be used without
it, remove the comb as described in par. "Removing the adjustable guide comb".
Instructions to adjust the cut.
The Clipper has four adjustable lengths: 0.5/1.0/1.5/2.0 mm.
• To adjust the cutting length, push the lever upwards 11 (fig. A1) in the direction of
the blade to cut very short hair (minimum height 0,5 mm).
• Press the unlock button 12 (fig. A1) and shift the lever downwards to cut longer
hair (maximum height 2,0 mm).
MAINTENANCE
In case of malfunction or damage to the appliance or a part of it,
the appliance must be analysed by the manufacturer or the relevant
technical assistance or in any case by a person with similar skills in
order to prevent any risk. The user must not disassemble the device
him/herself.
GENERAL CLEANING
It is recommended to clean daily or after every use.
Always disconnect the power cord from the mains socket before cleaning.
• Clean the exterior with a soft cloth or slightly damp cloth.
• After use, make sure that all parts are completely dry.
When cutting close to the ears, you are advised to use
your hand to protect your ear against injury.
Avoid all risk of electric shock by not cleaning the appliance
with water and do not immerse it in water.
Do not use abrasive solutions or concentrated detergents.
13