Brandani TRITACARNE 53361 Manual De Instrucciones página 15

HOW TO USE
Mincing
1. Insert the worm shaft into the cutter housing, the plastic end first. Fit the cutter
blade unit onto the other end of worm shaft.(The cutting edge should be placed at the
front side). And then you can also fit the coarse/medium/fine grinding disc(Depending
on the consistency you prefer). Make sure the notch of the grinding disc fit into the
projection on the opening of cutter house. Fit the screw ring on the cutter housing by
turning the screw ring clockwise until it is properly fastened.
2. Fit the cutter housing on the motor unit. The lugs on the
motor unit must fit precisely into the slots on the cutter
housing. Rotate the cutter housing anti-clockwise until hear a
click. The cutter housing is then locked in the position You can
remove the cutter housing by pressing the release button on
the appliance and turning the cutter housing clockwise.
INSTRUCTION MANUAL