Disposal; Technical Data; What If There Are Problems - Beurer BY 76 Manual De Instrucciones

9.

Disposal

In the interests of the environment, the device cannot be disposed of in normal household waste at
the end of its service life. Disposal can take place via respective collection points in your country.
Follow local regulations when disposing of the materials.
Dispose of the device in accordance with the EC directive on old electric and electronic
devices – WEEE (Waste Electrical and Electronic Equipment).
If you have queries, contact the appropriate local authorities.

10. Technical data

Supply voltage:
Output:

11. What if there are problems?

Fault
The device does not switch on
after the cable is plugged in.
The device switches itself off after
the warming up phase, there are
no more displays.
The device switches itself off
midway through the process, and
there are no more displays.
No LED display
12
220 - 240 V ~ / 50/60 Hz
500 watts
Cause
No electricity
No water in the
steriliser
Too little water in the
steriliser
Mains plug not (prop-
erly) plugged in or
faulty device
Action
Check that the plug is properly
plugged in.
Unplug the device, allow it to cool
down, then fill it with 120 ml water
and start the programme as de-
scribed in the instructions.
Check that the mains plug is (prop-
erly) plugged in. If there is still no
display, switch the device off, unplug
it and return the device to the retailer.