Gardebruk GBMH02 Instrucciones página 27

Spare parts ordering:
The following information should be provided when ordering spare parts;
• Appliance type
• Item number of the appliance
Cutters (blades)
7.2 STORAGE
To protect the unit from corrosion when stored for long periods, treat the cutting blade with
suitable oil (e.g. gun oil).
Make sure that the appliance has been carefully cleaned before storing it in a clean, dry place out
of the reach of children.
7.3 REPAIR SERVICE
WARNING! Electrical repair work may only be carried out by a qualified electrician or a customer
service workshop!
8.0 TROUBLESHOOTING
WARNING! In the event of an accident or malfunction, first stop the appliance, disconnect the
mains plug from the mains and make sure that all moving parts are at a complete standstill. Then
check the unit etc. or contact our customer service.
Problem
The motor won't
run
Material to be
shredded is not
drawn in
9.0 TECHNICAL DATA
Item number
Model
Mains voltage / Grid frequency
Nominal power
No-load speed
Max. branch thickness
Measured sound pressure level
Measured sound power level
Guaranteed sound power level
Cable length
Protection class, degree of protection
MH1
Possible cause
Motor protection tripped
Power supply interrupted
Safety switch (B) is not triggered
Material jam
Blades are blocked
Blades are worn
Solution
Remove all shredded pieces and
restart
Check mains cable, mains plug and
fuse.
Check the connection between the
main housing and the motor housing.
Remove all
material from the blades.
Remove all shredded pieces and
restart the shredder.
Replace blades as necessary.
106536
GBMH02
230-240 V ~50 Hz
2400 W（P40), operating time P40 (full load:
40 s, idle: 60 s)
4800 rpm
45 mm
LPA = 87.2 dB, KPA= 3 dB
LWA = 102.5 dB, KWA= 3 dB
106 dB
0.35 m
II, IP24
27
pieces of shredded
www.DEUBAXXL.de