Publicidad
Idiomas disponibles
Idiomas disponibles
USING YOUR MONDIAL FLEX HAIR CLIPPER
• Remove the Hair Clipper from the Charging Base (7).
• Inspect the cutter, making sure there is oil between the teeth of the Cutting Blades (1), turn on the
unit to spread the oil and to make sure it is operating properly. Repeat this procedure after each
use.
• Position a mirror approximately at your eye level. This will give you better visibility and greater
control while cutting your hair.
• Choose the cut length that best suits the desired cut length using the Clipper Guide Setting
Key (4) via the Height Selector knob, located at the rear of the unit:
Clipper Attachment 1
1 approximately 1/8"
2 approximately 1/4"
3 approximately 3/8"
4 approximately 15/32"
5 approximately 19/32"
• Start with height #5 and switch until you reach the desired cut length.
• For hair length under 1/8", use the clipper without any attachments.
• Comb hair to untangle it, avoiding obstructions to the blade. Make sure to comb it along the
direction it grows.
• ON/OFF Switch
• Hold the clipper with the teeth of the comb facing up, but with the base of the blades resting
flat on the scalp.
• Never push the clipper hard or move it fast. The clipper works best when used slowly.
• Start cutting your hair from the sides, and from the bottom up. Slowly lift the clipper through and
out of the hair, cutting only a small amount of hair at a time.
• Repeat the process at the back of the head.
• On the top of the head, you can get a longer cut with heights #4 and #5. With the appliance
resting flat against your scalp, start cutting slowly from front to back.
Clipper Attachment 2
1 approximately 11/16"
2 approximately 13/16"
3 approximately 15/16"
4 approximately 1 1/16"
5 approximately 1 3/16"
17
Publicidad
