Maintenance And Service; Maintenance And Cleaning - Bosch GEX 125-1 A Professional Instrucciones De Servicio

Rough Sanding
Attach a sanding sheet with coarse grain.
Apply only light pressure to the machine so that it runs
at high speed and high material removal is achieved.
Fine Sanding
Attach a sanding sheet with fine grain.
By lightly varying the application pressure or changing
the speed stage (GEX 125-1 AE), the sanding plate
speed can be reduced whereby the orbital action is
maintained.
With moderate pressure, move the machine in a circu-
lar pattern or alternately in lengthwise and crosswise
directions over the workpiece. Do not tilt the machine
to avoid sanding through the workpiece (e. g. when
sanding veneer).
After finishing the working procedure, switch the
power tool off.
Polishing (GEX 125-1 AE)
For the polishing of weathered paint or buffing out
scratches (e. g., acrylic glass), the machine can be
equipped with appropriate polishing accessories
such as lamb's wool bonnet, polishing felt or sponge
(accessories).
Select a low speed for polishing (stage 1 – 2) in order
to avoid excessive heating of the surface.
Apply polishing agent crosswise or in a circular
motion with a polishing sponge and moderate pres-
sure, and then allow it to dry lightly.
Polish the partially dried polishing agent with cross-
wise or circular motions using a lamb's wool polishing
bonnet.
Clean the polishing accessories regularly to ensure
good polishing results. Wash out polishing accesso-
ries with a mild detergent and warm water; do not use
paint thinner.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
Bosch power tools.
In all correspondence and spare parts order, please
always include the 10-digit article number given on
the type plate of the machine.
24 | English
WARNING! Important instructions for connect-
ing a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to the
following code:
Do not connect the blue or brown wire to the earth
terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it must be
disposed of safely.
Guarantee
We guarantee Bosch appliances in accordance
with statutory/country-specific regulations
(proof of purchase by invoice or delivery note).
Damage attributable to normal wear and tear,
overload or improper handling will be excluded
from the guarantee.
In case of complaint please send the machine,
undismantled, to your dealer or the Bosch
Service Center for Electric Power Tools.
Warning!
Freight and insurance costs are charged to the
client, even for warranty claims.
Service and Customer Assistance
Exploded views and information on spare parts can be
found under:
www.bosch-pt.com
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must be collected sep-
arately and disposed of in an environmentally correct
manner.
Subject to change without notice.
F 000 622 258 . 10.11.08