Hart SLIDER Manual De Usuario página 4

EN
placed in the right position on the shell formed by the
main tubes. Mount the rear net, if your model has this
feature.
6. Continue to infl ate the main tubes up to the fi nal
pressure (maximum 0.25bar/3.6 psi). Then close the
valves (with 1/4 of a turn clockwise).
7. Should there be a problem during the infl ation
process, then completely defl ate the tube in question
and half defl ate the other one (see "Defl ation" below). Check that the fabric lies fl at and
is not twisted, preventing correct air fl ow. Go back to point 4 and repeat the procedure.
8. If your fl oat tube model is equipped with oars as accessories, then assemble the
parts and fi x them securely to the supports.
9. The spreader bar and the front plastic-coated stripping apron (for those fl oat tube
models that include these accessories) should be secured to the tubes once you are
seated on the fl oat tube, in the water.
10. The Slider model also has a keel and keel support,
"torpedo" type electric motor support and "standard"
type outboard electric motor. If you are going to use a
fl oat tube with an outboard electric motor, the motor
support should be mounted in the correct position. If
you are going to use a torpedo type electric motor or
the keel, then mount them on the support just when
you are going to put the fl oat tube in the water, to
avoid damage.
Maximum recommended load:
Your fl oat tube has a maximum recommended load of:
• 200 kilos - models: SLIDER, GUARDIAN, SIKKARIO
• 130 kilos - models: VENDETTA.
• Once the fl oat tube has been infl ated to its operating pressure, it should
not be left out of the water in direct sunlight for long periods of time. High
temperatures could increase the air pressure inside the craft, causing it to
expand. This overpressure could burst the fl oat tube bladders.
• If you need to take your fl oat tube out of the water for some time, leaving
it exposed to the sun, then simply partially defl ate it by approximately one
quarter of its air volume.
• On extremely hot days, there may be overpressure, even when fi shing in the
water. Should this happen, simply correct this overpressure by releasing the
excess air until the correct pressure has been reached.
USER´S GUIDE -
4
HART FLOAT TUBES