Publicidad
Idiomas disponibles
Idiomas disponibles
Reversing the door
The door can be changed from left and right side. No special requirement, all the door is opened from left side. If required
to open from right side please refer to the following direction.
1. Lower hinge (right)
4. Door
7. Top hinge (left)
10. Door limit device
1. Open the door to 90 degrees, remove the two screws (2) from the lower door axis (3), remove the door (4) and door
axis (Fig. A).
2. Position the door (4) safely and remove the plug (12) from the top of the door frame. Unscrew one screw (11) at the
bottom and remove the door limit device (10). Install the door limit device (10) at the top of the door frame. Please use
the spare plug (12) to block the hole at the top of the door frame (Fig. A/B).
3. Take out three hinge screws (6) from the upper hinge (right) (5) and remove it (Fig. C).
4. Remove the decorative nail (8) from the top left of the cabinet and install the spare top hinge (left) (7) on the top left
of the cabinet with three screws (Fig. D).
5. Install the spare lower hinge (left) (9) according to the above procedure (Fig. E).
6. The door opens to 180 degrees. Install the door in the same way as it was removed and fix it so that the door is
aligned.
7. Block the hole at the top right of the cabinet with the spare decorative nail (8).
5. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5- 20°C.
The ambient temperature has an impact on the interior temperature and humidity of your cellar. For optimal
operation, the settings of your cellar are made for ambient temperatures of 23°C to 25°C.
2. Screws
5. Top hinge (Right)
8. Decorative nail
11. Screw
3. Door axis
6. Hinge screws
9. Lower hinge (left)
12. Plug
43
Publicidad
