OK. ODW 6011 A2 FS B Manual De Instrucciones página 18

Size = A5
EN
INSTALLATION
Note: The dishwasher is equipped with power cord and plug. Make sure before installation that a wall
outlet is at the desired place of installation.
Consider the dimension of the product for placing and installation.
1
Place the dishwasher on an even, horizontal and steady surface.
Note: The dishwasher is not intended to be built in.
The dishwasher must be connected to drainage.
2
1. The hose is already connected the waste water outlet. Cut the straps and unwind the hose.
2. Connect the end to a drainpipe (Option A or B). Observe the max. height of the outlet of
drainage hose.
Note:
A suitable hose holder is available as optional accessories.
Connect the water inlet to tap water supply (3/4") using the pre-assembled hose and make sure it
3
fastened tightly.
Note: If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear and free of impurities. If this precaution is not taken,
there is a risk that the water inlet can get blocked and damage the appliance.
Connect the power plug to the mains.
4
Note: Before using the product for the first time, make sure, that all hydrophilic connections of the
product are correctly sealed and connected to both the device as well as the water mains. Check all
connections periodically to avoid possible leakage.
PREPARATION
Filling salt into the salt container
Depending on your tap water hardness (hardness degree) use additional salt (water softener).
5
Always consider instruction provided with the salt.
1. Remove the basket and then unscrew and remove the cap from the salt container.
2. Before first wash, add 1.5 lt. of water in the salt container of your machine.
3. Place the end of the funnel (supplied) into the hole and introduce about 1.5 kg of salt. It is
normal for a small amount of water to come out of the salt container.
4. After filling the container, screw the cap tightly back clockwise.
5. Immediately after filling the salt into the salt container, a washing program should be started
(rapid program suggested). Otherwise filter system, pump or other important parts of the
machine may be damaged by salty water which voids the warranty.
Note: Depending on how fully the salt dissolves, the salt warning light may still be on even though
the salt container is filled.
Warning!
• Only use salt specifically designed for use in dishwashers! All other types of salt not specifically
designed for use in a dishwasher, especially table salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor is
liable for any caused damages.
• If salt has been spilled a soak or a rapid program should be run to remove the excess salt.
• Only fill with salt just before starting one of the complete washing programs. This will prevent any
grains of salt or salty water, which may have been split, remaining of the bottom of the machine for
any period of time, which may cause corrosion.
• The salt container must only be refilled when the salt warning light in the control panel comes on.
IM_ODW6011 A2 FS B_190415_V04_HR.indb 18
18
15/4/2019 13:44