HOMCOM 852-012 Manual De Instrucciones Y Montaje página 9

1.Place the attachment on the suction head with the rubber wiper blades until you hear it
lock in.
Note: Depending on the size and accessibility of the surface to be cleaned, use the corre-
sponding attachment (wide or narrow)
2.Attach the spray bottle and wiper attachment and fill it with detergent.
3.Attach the pad holder.
Remove the spray head from the spray bottle.
Attach the micro-fibre pad to the spray head.
Secure the micro-fibre pad to the spray head with the ring clamp.
CHARGING THE BATTERY
1.Insert the charger into a proper socket.
2.Insert the charging cable plug to the back of the appliance.
Note: During the charging process, the charge/operating display blinks. Blinking stops
once the battery is fully charged.
3.Recharge the battery after use.
Cleaning with spray bottle and micro-fibre pad
1.Press the spray lever on the bottle to apply the detergent and spray the surface evenly.
After, loosen the dirt using the micro-fibre pad. Note: Rinse pad under running water if
needed.
2.Switch the appliance on. The charge/operating display should light up.
3.Maneuver the appliance from top to bottom or sideways to vacuum up the detergent.
Note: Switch the appliance off after each cleaned surface. This will increase your operating
time per battery charge. If the battery is losing power (the display light is blinking),
recharge the battery.
Cleaning without the spray bottle
1.Apply the detergent to loosen the dirt.
2.Switch the appliance on. The charge/operating display should light up.
3.Maneuver the appliance from top to bottom or sideways to vacuum up the detergent.
Emptying the tank
Once the maximum capacity level of the removable recovery tank is reached please empty
the tank.
1.Turn off the appliance.
2.Pull off the lock of the removable recovery tank and empty it.
3.Place the tank back and close it.
ASSEMBLY
OPERATION
9