Xavax 00111822 Instrucciones De Uso página 4

G Operating instruction
Thank you for choosing a Xavax product.
Take your time and read the following instructions and
information completely. Please keep these instructions in a
safe place for future reference. If you sell the device, please
pass these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to
draw your attention to speci c hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Safety Notes
• The product is intended for private, non-commercial
use only.
• Children are not permitted to play with the device.
Children may not clean the product or perform user
maintenance without supervision.
• Do not operate the product outside the power limits given
in the speci cations.
• Never apply force when using the product or during
installation.
• Do not attempt to service or repair the product yourself.
Leave any and all service work to quali ed experts.
• Do not open the device or continue to operate it if it
becomes damaged.
Warning
• Before carrying out the installation, it is imperative that
you carefully read and follow the instructions provided
by the manufacturer of the appliance (refrigerator),
in order to avoid damage to property through water
leakage.
• If necessary, check that your water pressure is below
100 psi / 7 bar (it is best to do this with the help of a
professional).
• Get a plumber or an authorised installer to carry out the
installation if necessary.
2
1. First, turn off the main water line and disconnect the
refrigerator from the mains supply.
2. Pull off the retaining ring (C).
3. Lightly press the pipe connector (B) downwards and keep
it pressed as you pull out the plastic bung (A). Repeat
the procedure on the other end of the lter. Note: if the
pipe connector (B) is pulled out of the lter, it must be
reinserted.
4. Take the pipe for the ice maker (1/4 inch) and cut it
straight with a knife. The cut must be square (90°), so
that the connection seals. Push the pipe rmly into the
water lter as far as it will go (approximately 17 mm
deep). Make sure that you observe the water ow direction
(FLOW è) displayed on the water lter!
5. Replace the retaining ring (C).
6. Turn on the water supply and check the complete system
for leak tightness. Repeat the installation if necessary.
7. Flush the lter in accordance with the appliance
manufacturer's guidelines (see operating instructions for
refrigerator).
Note
Check the system 24 hours after installation. If you nd
dripping connections, repeat the installation steps for the
respective connection.
3. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
4. Technical Data
Operating temperature
Operating pressure
Rated capacity
Flow rate
0,6°C -38°C
30 psi / 2 bar – 100 psi / 7 bar
5000 l (1320 gallons)
2,5 l / min 0,66 gpm