Ferroli VHM 2.1 Instrucciones De Montaje página 38

InstructIons for InstallatIon on a slopIng roof
Contents of kit (used for only one collector)
code 076224x0 for model 2.1
code 076225x0 for model 2.7
1 - Assemble the supporting structures accord-
ing to the number of collectors to be installed,
fitting the profiles together (fig. 3).
fig. 3
3 - Secure the supporting structures to the previously prepared fixings on the roof, depending on the type of covering (fig. 5), following
the instructions contained in the kit.
Note: If high stresses for the structure (e.g. heavy snowfall, wind gusts, etc.) are foreseen, it is advisable to increase the fixing
points as shown on the diagram of fig. 1 and fig. 2.
Important: The weights of the collector and any additional weights will be supported by the brackets which in turn will support the roof-
ing tiles. Therefore properly assess the load capacity before installation
Installation on bent tiles
Min.
65 mm
4 - Establish the position of the top bracket following the indications in fig. 6.
fig. 6
EN
38
X4 X2
2 - Fit the brackets (fig.4)
Installation on flat tiles
10 Nm
Cod. 3541I450 - Rev. 03 - 02/2017
X2
(60x25x1095)
X2
(60x25x1395)
fig. 4
10 Nm
fig. 5
VHM 2.1 - 2.7
X4
X2
(M8x75 hex.
(55x20x295)
socket)
Installation with studs
20 Nm