Hoover NDP4 H7A2TCBEX-S Manual Del Usuario página 55

Make sure that the electrical
l
system is earthed, complies
with all applicable law and that
the (electricity)
compatible with the plug of the
appliance. Otherwise,
qualified professional assistance.
WARNING
The appliance must not be
supplied through an external
switching device, such as a
timer, or connected to a circuit
that is regularly switched on
and off by a utility.
Do not use adapters, multiple
l
connectors and/or extensions.
The plug should be accessible
l
for disconnection
appliance has been installed.
Do not plug the machine in and
l
switch it on at the mains until
the installation is completed.
If the supply cord is damaged,
l
it must be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard.
Ventilation
l
socket is
seek
l
l
l
l
after the
l
l
55
Adequate ventilation must be
provided in the room where the
tumble dryer is located to
prevent gases from appliances
burning other fuels, including
open fires, being drawn into
the room during operation of
the tumble dryer.
Install the rear of the appliance
close to a wall or vertical surface.
There should be a gap of at
least 12 mm between the
machine and any obstrubtions.
The inlet and outlet air should
be kept clear of obstruction.
Make sure carpets or rugs
do not obstruct the base or any
of the ventilation openings.
Prevent items from falling or
collecting behind the dryer as
these may obstruct the air inlet
and outlet.
Exhaust air
discharged into a flue which is
used for exhausting fumes
from appliances burning gas or
other fuels.
Check regularly that the air
flowing around the dryer is not
restricted, avoiding accumulation
of dust and lint.
must not be