Jata JECL1900 Instrucciones De Uso página 10

• The appliance must only be used with the base provided.
• Disconnect from the mains before removing it from its base.
• Always use with the lid on.
• The device is intended to be used in domestic and similar
applications such as:
- By clients in hotels, motels and other residential-type
environments;
- Hostel-type environments (bed and breakfast in English)
- Excluding staff kitchen areas in shops, offices and other
work environments;
- Excluding farms.
• The cleaning and maintenance done by users, can not be done
by children without any supervision, unless they are over 8
years and they are under supervision.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
INSTRUCTIONS OF USE
• Remove the lid (1) from the jug (2) and pour milk into it.
• Bear in mind that the milk must be between minimum and maximum level indicators which are indicated
(3) inside the jug (2).
-Maximum level " " to foam
-Maximum level " " ot heat
• Put the lid (1) back on, pressing it so that it fits correctly.
• Place the jug (2) on the base (5).
• If you want to foam, place the frothing accessory (6) inserting it into the anchor (7), to remove it, pull it. It
can be used hot and cold.
• Plug the appliance to the mains and press the on switch (4).
-1 pulsation: Hot.
-2 pulsations: Cold
-3 pulsations: OFF
• The indicator switch light will light on the chosen program and the milk start heating.
• Wait for some minutes until the milk has reached the correct temperature, when this happens the light
switch will flash and go off.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning it, ensure the appliance is unplugged from the mains.
• The base (5) may be cleaned with a dry cloth same as the base of the jug.
• Clean the outside of the jug with a slightly dampened cloth.
• In the inner side can be cleaned with water and with soap suitable for the dishwasher and next rinse
properly. Never immerse in water or rinse the outer side of the appliance.
• Do not use chemical or abrasive products, such as metallic scourers, which may deteriorate the surfaces of
the appliance.
10