Starmix StarSweep 65 Manual De Instrucciones página 10

Operation
WARNING
Risk of cutting due to broken glass, metal
or other sharp-edged materials.
When emptying the sweeping container,
cutting injuries may occur due to broken
glass, metal or other sharp-edged materials.
• Wear the prescribed personal protective
equipment.
CAUTION
Health impairments caused by dust
resulting from sweeping.
The inhalation of dusts can endanger the
health.
• Wear the prescribed personal protective
equipment.
Before starting work
• Installing brush and sliding bracket, see page 2.
• Check the device to make sure that it is
functioning before starting work.
• Check whether the sliding bracket fits firmly.
• Check the sweeping container to make sure it is
firmly seated and in good condition.
• Check the plate brooms for jammed items or
contamination.
• Check the handles for contamination and clean if
necessary.
Operation
• Operate the device via the sliding bracket with both
hands.
• Push the device forward at normal walking speed.
• Empty the sweeping container as needed.
Empty the sweeping container
• Empty the sweeping container after each use.
• Empty the sweeping container at regular intervals to
achieve a proper sweeping result.
1 st Pull the sweeping container upwards by the
handle.
2 st Empty the sweeping container completely.
Make sure that the enclosure sides are free of dirt.
3 st Insert the empty sweeping container on the device.
Troubleshooting
WARNING
Risk of cutting due to broken glass, metal
or other sharp-edged materials.
When emptying the sweeping container,
cutting injuries may occur due to broken
glass, metal or other sharp-edged materials.
• Wear the prescribed personal protective
equipment.
CAUTION
Health impairments caused by dust
resulting from sweeping.
The inhalation of dusts can endanger the
health.
• Wear the prescribed personal protective
equipment.
CAUTION
Risk of injury through tipping over of the sliding
bracket.
Tipping over the push bar can result in minor injuries
such as e.g. crushing of the fingers or bruising of the
user or other persons.
• When carrying the device, hold it so that the sliding
bracket cannot tip over.
Malfunctions may occur even if the prescribed
maintenance work and checks of the device before
use are complied with. Possible faults are listed in
the table below with specification of the cause and
remedy.
Fault Cause
Device is
contaminated
Device is
running
Broom blocked
with difficulty
or roughly
Contaminated
broom drives
Bristles are Improper
bent storage
• Dispose of the device in an environmentally friendly
manner in accordance with the applicable regional
regulation.
10
Remedy
Clean the device
Remove
blockage
Clean broom
drives
Store the device
correctly and
replace the plate
brush if
necessary
Disposal