Pur Line HYDRO 15 Manual De Instrucciones página 9

Open the water tank cover. Fill the top with clean cold water (max.40ºC).
1. ON/OFF
Connect the plug and touch the POWER key , LCD screen lights up the machine start
working.touch the Power key again, it stops working and keep in standby state.
2. HUMIDIFY
The Mist is divide to 3 gears. low/medium/high mist can adjust by user. the default of
startup is high mist.
3. TIMER
Timer setting fuction.It can automatically shut down and enter standby state at fixed time
for 1/2/4/8 hours, LCD screen will show the timing.
4. HYGROSTAT
Humidity function start by pressing this key and the "HUMID" flickers on the LCD screen;
the default humidity is 45%, then increases by 5% until 90% and log out humidity function,
auto adjusting circularly till it same as ambient humidity. the machine will stop working.
5. SLEEP
Pressing the key under working state, intelligent humidity 65%, screen "HUMID" icon to
flicker for 5s, then auto shuts down the screen and keeps the original gear working. After
the function is started,-press any keys to light up the screen and the current working state.
press this key again and exit this function; if no operation in 5s, the screen will close again.
REMOTE CONTROL: has the same functions that the control panel.
CLEANING AND MAINTENANCE
In case when the water is hard which means water contains too much calcium and magnesium, they can cause
"white powder" problem and give heavy scum on the surface of water basin, transducer and inner surface of
the water tank. Scum on the surface of transducer will make the unit work improperly.
WE RECOMMEND:
• Use filtered water or distilled water.
• Clean the transducer, water tank and basin unit every week.
• Change the water in water tank more often to keep it fresh.
• Clean the whole unit, and make sure to keep all parts of the unit dry completely when the unit is not in use.
HOW TO CLEAN THE TRANSDUCER:
for 2-5 minutes. 2. Brush out the scum on the surface. 3. Rinse the transducer with clean water.
HOW TO CLEAN THE BASIN UNIT:
scum in it. 2. If the scum is covered on the security switch, drop the vinegar on the scum and clean it out with
the brush. 3. Rinse the water basin with clean water.
CLEAN THE TANK FILTER:
Shake about 10 times and rinse with water. 4. Leave to dry.
EN
Close the water tank cover.
1. Put 5-10 drops of vinegar on the surface of the transducer, wait
1. Clean the water basin with soft cloth and the vinegar if there is
1. Remove the filter from the tank. Clean with a little vinegar and clean water. 3.
7