Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not use the device if it has previously been dropped.
• Do not use the device if it exhibits visible signs of damage.
• Do not remove the mains plug from the socket by pulling on the mains cable.
• Never insert or remove the mains plug with wet hands.
• This device may be used by children over the age of 8 and by persons with reduced physical,
sensory or mental capabilities or a lack of experience and knowledge, provided that they are
supervised or have been instructed on how to use the device safely and understand the risks
involved. Children must not play with the device. Do not allow children to clean the device or
perform user maintenance without supervision.
• The appliance must only be used with the power supply unit provided.
• The plugs of electrical appliances must be compatible with the socket. Never change the plug.
Do not use adapter plugs with earthed electrical devices. Original plugs and matching sockets
reduce the risk of electric shock.
• Do not use any USB wire length exceed 3 meter for charging.
INTENDED USE
The table lamp is for indoor use only and must not be used in wet rooms. Use the product only
for the purpose it is intended for. The manufacturer accepts no liability for damage caused by
unintended use. Any modification to the product may negatively impact safety, cause hazards and
invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove the product. After unpacking, please check the product for damage
and to ensure it is complete. Subsequent complaints cannot be accepted.
FIRST USE
1.
Insert the plug (E) into the corresponding socket (D) below on the back of
the LED lamp (A) (see Fig. 1).
2. Touch the On/Off (2) sensor on the lamp socket to switch on the light with a brightness level
of 30%. Touch the "Increase brightness" (3) sensor, allowing you to gradually increase the
brightness to 30%, 70%, and 100%, and with the "Reduce brightness" (4) sensor, you can
gradually reduce the brightness accordingly (see Fig. 1).
3. While the lamp is connected to power, you can charge mobile phones, tablets, or similar
devices with a USB port using the USB charging port (C), even if the lamp is off.
4. Adjusting the position of the lamp arm and head: Hold the lamp socket steady when adjusting
the lamp arm and lamp head. The lamp arm can be moved up to 135°, and the lamp strip up
to 90°. The lamp can be completely folded together (see Fig. 2).
USAGE (graphic on page 2 and 3)
A
LED lamp
B
Power supply unit
C
USB charging port
D
Socket
E
Plug
1
Light colour selection
2
On/off
3
Increase brightness
4
Decrease brightness
9
www.DEUBAXXL.de
Publicidad
