ErgoAV ERMTS1-01B Manual De Instrucciones página 12

Step 2B Solid Concrete Wall Option
WARNING:
Do not use a drill for tightening the lag screws! Only use a socket wrench.
● Avoid potential personal injury or property damage! DO NOT over-tighten the lag
screws [A1]. Tighten the lag screws [A1] is pulled firmly against the wall plate.
● Ensure the wall plate is securely fastened to the wall before
continuing to the next step.
● Mount the wall plate directly onto the concrete surface without
any covering.
● The thickness of the concrete wall must exceed 5.5 in (140 mm).
2B-1
2B-2
Wall Thickness
≥5.5 in
(140mm)
Position the wall plate [01] at
your desired height. Level the
wall plate [01] and mark the
pilot hole locations.
01
Drill 3 pilot holes using a
3/8 in (10mm) diameter drill
bit. Make sure the depth is
not less than 3 in (75mm).
11
Level
(Not Included)
3 in (75mm)
Electric Drill
3/8 in (10mm) (Not Included)
Wall
Anchor
A2
Pencil
(Not Included)