Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Ensure the gasket (B) is on the bottom of the
new faucet (A).
□
Place the faucet (A) through the mounting
holes in the sink.
□
Secure the faucet (A) to the sink using the
mounting nuts (C) provided. Hand-tighten only.
NOTE: Silicone sealant is required under the gasket (B).
2
A
B
C
4
Attaching the quick connector
to the receiving block
□
Push the quick connector (D) rmly upward and
attach it to the receiving block (1). Pull down
moderately to ensure the connection has been
made.
1
D
Publicidad
