Tivoli Audio Two Digital Manual Del Usuario página 7

Your Model Two Digital can be used as a standalone speaker. Simply use an 1/8" stereo cable to attach any line or
headphone level source into the AUX input on the back of your speaker. On the front of your speaker, short press
the power knob until the LED is Orange. You can control the volume of the speaker using the volume control on
the Model Two Digital or with the volume control of your audio source.
Pairing
Your Model Two Digital can act as a standalone Bluetooth speaker.
1. Turn on your unit by short pressing the power knob.
2. On your speaker, short press the power knob until the LED Light Bar is Blue.
3. The LED light will flash blue, indicating pairing mode. If your speaker is not in pairing mode, press the BT
Button on the rear of the speaker.
4. Go to the Bluetooth settings on your phone or tablet.
5. Select the device that has a name similar to "Tivoli Audio M2D_XXXXXX".
6. Once the LED Light Bar shines solid blue, you are paired to the radio. After 5 seconds, the light will revert to
soft white.
7. You can begin playing your music via Bluetooth.
Wi-Fi Setup with Apple AirPlay 2
1. Turn on your unit by short pressing the power knob.
2. Set your speaker to Wi-Fi mode by short pressing the power knob until the LED light is Green. The LED will
blink green, indicating Wi-Fi Setup mode. If your speaker is not in Wi-Fi Setup mode: short press the "Wi-Fi"
button on the rear of the unit.
3. On your iOS device, go to Wi-Fi Settings. Make sure to connect your iOS device to the network that you intend
to use your Model Two Digital.
English
Auxiliary Mode
Bluetooth Mode
WiFi Mode
6