Installation And Connection; Remedy Of Faults - Pontec PondoStar LED Set 6 Instrucciones De Uso

Installation and connection

 B, C
Ensure that units are positioned and secured such that they cannot present a hazard:
 Install the transformer at a minimum safety distance of 2 m from the water.
 Install the twilight sensor outside of the water with the sensor eye pointing upwards.
 Position the lights outside of the water or in the water and tilt the light head as desired.
How to proceed:
1. Connect the plug of the spotlight connection cable to the socket on the twilight sensor and hand-tighten the union
nut.
– Alternatively: Connect the spotlight to the transformer without the twilight sensor in-between.
2. Connect the connection cable of the twilight sensor to the socket on the transformer and hand-tighten the union nut.
Commissioning/start-up
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
 Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into
the water.
 Isolate the unit before starting any work.
 Secure the unit to prevent unintentional switching on.
Sensitive electrical components.
Possible consequences: The device will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
Switching on: Insert the power plug of the transformer into the socket.
 Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.

Remedy of faults

S
Malfunction
Lamp does not light up.
Luminosity decreasing
Cause
Power supply interrupted
Twilight sensor soiled or defective
Transformer defective
Lamp glass soiled
Remedy
Check power supply
Clean or replace
Replace transformer
Clean
- EN -
9