Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
Use an extension cable to connect the device to a power outlet (230 V AC) (see Figure 4).
4
Turn on the device by pressing the „ON/OFF button" D in the „handle" A.
5
Full operating temperature will be reached after approx. 1 minute (see Figure 5).
CAUTION
Risk of burns caused by hot air!
Never direct the hot air stream at humans or animals.
Risk of burns caused by hot parts!! Do not touch „conical jet" J or „heat shield" I.
During breaks in work, release the „ON/OFF button" D and place the device with the
„support stand" F opened on a level fireproof surface (see Figure 8).
To eradicate weeds, direct the „conical nozzle" J at the plant to be treated for 5-10 sec-
5
onds according to the type of plant (see Figure 5).
In the case of tall plants, first only briefly heat the the upper section of the plant and then
6
direct the „conical nozzle" J at the shrunken plant for approx. 5-10 sec. (see Figure 6).

6.2 User information

The device is particularly suitable for the removal of weeds.
The device is most effective if the plant has a high sap content. The best time for treating
wild growth is in the spring. The effect is more intense, the younger the growth is. Howev-
er, the results are not immediately visible. Visible parts of the plant can also be burned as
part of a longer exposure time.
The sensitivity of the plants to the heat radiation is not immediately evident during the
recommended exposure time. In principle, the following applies: soft-leaved seedlings are
the most sensitive, in other words, they will not survive a single treatment.
Older plants with hard leaves, such as thistles, will dry out after several treatment at inter-
vals of one to two weeks. Sclerophyllous grasses are extremely robust and require a longer
time for the heat to take effect.
In the initial phase, wild growth growing on/through surfaces should be treated briefly sev-
eral times. Only then are lasting results guaranteed.
After this, treatments at longer intervals will be sufficient.
Weeds need only be heated. It is not necessary to burn them. This dries out the Cells of the
leaves and the weed dies back.
Certain weed species require repeated treatment.
The device is also suitable for rekindling glowing embers in a charcoal grill in the open
7
air. Hold the conical nozzle of the switched-on device close to the charcoal. As soon as
the charcoal embers begin to glow, the hot air flow will rekindle the flame. Then hold
the device further away from the charcoal.
CAUTION! Fire hazard caused by flying sparks!
Hold the device at a distance from the charcoal to avoid sparks.
18

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

000173.0000

Tabla de contenido