LF allen + roth LWFP62-8 Instrucciones De Montaje página 7

ASSEMBLY INSTRUCTIONS
19. Insert eight shelf supports (JJ) into the desired holes inside each
side compartment. Make sure you place the four shelf supports
at the same level to level the shelf. Tilt and rest the adjustable
shelves (V) onto the shelf supports (JJ).
Hardware Used
JJ Shelf Support
20a. Put the paper stickers (KK) onto the visible cam locks and
screws.
20b. Stick the rubber bumpers (LL) on the outer corners of doors
where are contact with the partition panels (T and U).
Hardware Used
KK Paper Sticker
Rubber Bumper
LL
Installing the fireplace insert
IMPORTANT NOTE: Use hand screwdriver, not power driver to assemble
fireplace insert. See BILT for video instructions.
21a. See figure A: Fasten upper 2 screws (AA) through the upright arm
(C) into the heater (A) until tight.
21b. See figure B: Fasten lower 2 screws (AA) into the upright arm (C)
until tight.
21c. Fully tighten all 4 screws (AA) one final time.
21d. Repeat the same process with upright arm (B).
WARNING: Do not lift or transport the heater by using the upright arms.
Hardware Used
AA M4 x 10 mm Screw
19
x 16
V
JJ
20
x 14
x 4
T
LL
21
Figure A
A
C
AA
B
C
x 8
A
12 Lowes.com/allenandroth
ASSEMBLY INSTRUCTIONS
IMPORTANT: Carefully follow the 2 steps below for inserting each log.
22a. Install left log (F) into left hole of ember bed (E) by inserting front
edge of base of the log into front notches of ember bed hole.
22b. Then tilt the log back to insert the rear edge of the log base into
rear notches of ember bed hole (press down log firmly to lock into
position).
22c. Repeat the above process for the right log (G).
G1
JJ
23a. Set the ember bed (E) onto the heater (A) as shown.
23b. Push ember bed forward against the front flange of heater.
23c. Position the USB cable as shown.
KK
U
C1
LL
24a. Fold the wall panel (H) as shown. Then position yourself at
back side of heater (A).
24b. Hold wall panel (H) at the angle shown below and insert lower
back edge into metal slots on back of heater (A).
Figure B
24c. Tilt wall panel (H) forward until bottom corner inserts into lower
U-channels on both upright arms (B and C).
C
A 24d. Continue to tilt wall panel (H) forward until the top corner inserts
into upper U-channels on both upright arms (B and C).
AA
22
F
F
E
1
G
F
E
23
A
USB cable
24
U-channel
B
C
H
A
13
Lowes.com/allenandroth
E
2
E
E
A
H