Publicidad
Idiomas disponibles
Idiomas disponibles
the timer is set and completed, the timer LED is on during the timing period and the display returns
to the current humidity. After the timing is over, the timer LED turns off automatically.
In the running state, set the time to turn off the machine.
In the standby state, set the time to turn on the machine.
SPEED
Press button once to switch low speed
In laundry drying mode, sleep mode and defrosting period, the wind speed cannot be
changed.
CHILD-LOCK
Press 3 seconds to turn on/off the child lock function. After turn on "CHILD-LOCK", the button lights up.
Water Tank Full Alarm
Water Tank Indicator
When the tank is full, the water tank indicator turns red and the unit buzzes for 5 times.
Clear the alarm
When the buzz is on, press any button to stop it. The compressor and fan shut down and all the
functions freeze until the tank is emptied and back in right position.
Empty the tank
Grab the notches on the both sides of the tank and pull it out with both hands.
Take it slowly and steadily in case of spilled water.
DRAINAGE
There are two ways of removal collected water produced by the unit.
1. Manual draining: Empty water tank by manual.
2. Continuous draining: Use gravity to drain condensate water by attaching a drain hose.
1. EMPTYING THE WATER TANK
The water tank built in unit will fill up and shut the unit down once it is full. It will run again once
you empty the water tank and installed properly.
When the tank is full, the unit will make a buzzing sound, and the "Water Full" light will turn on.
Press the POWER button to turn off the unit.
Pull on the water tank and simply slide out of the body of the dehumidifier.
Empty the water into an area with a drain or outside.
Clean the inside of the tank as well as the outside.
Replace the empty tank back into the unit.
Press the POWER button to resume operating.
If the Water Full light does not extinguish, check that the float is correctly in place.
Press again to high speed.
.
EN-16
Publicidad
