nedis SCLU110GY Manual página 3

on the right end of the scale and remove the battery isolation
sheet before use.
How to Replace the Battery
LCD will display "Lo" when the battery power is low. Replace the
battery as follows:
1. Hold the scale in one hand. Use the thumb and index finger
of your other hand to pull out the battery case from the slot.
2. Push corner A outwards to release the used battery.
3. To insert a new battery, slide one side of the battery beneath
the retainer notches B & C. Press against the other side of
the battery until it clips underneath corner A. Make sure the
battery is inserted according to the polarity instructions.
4. Insert the battery case back into the slot on the scale.
Removable
battery
case / slot
hook
Room temperature
1. Press
shows zero. Press UNIT to view temperature (in Celsius and
Fahrenheit). Press UNIT again to revert to the normal
weighing mode.
2. When converting to temperature display mode the display
will show: "----". This means that the scale is testing the
triangular ring
webbing belt
luggage handle
to switch on the device. Wait until the display
notch C
3
notch A
notch B
Battery case