How To Install
5a. For Drywall Without Stud / Plasterboard:
Drill a 7/32"(5.5mm) hole into the drywall at each
pencil mark. Insert a drywall anchor into each hole.
Use a screwdriver or drill to insert the screws through
the lower hinge wall bracket into the drywall anchors.
Medium
Drywall
screw
anchor
5b. For Drywall with Stud:
Drill a 5/64"(2mm) pilot hole into the stud at each
pencil mark (no anchor needed).
Use a screwdriver or drill to insert the screws
through the lower hinge wall bracket into the stud.
Medium
screw
8
5a. Drywall
7/32"
5.5mm
5a. Plasterboard
7/32"
5.5mm
5b. Stud
5/64"
2.0mm
STEP 3: INSTALL LOWER CATCH (WALL BRACKET)
1. Place template "B" against
the wall with tape, flush to the
floor. Mark the screw holes with
a pencil to create indentation,
then remove the template.
2. Determine whether there is a
stud behind the drywall where
you will install the lower catch wall
bracket. Proceed to either 3a or 3b.
3a. For Drywall Without Stud / Plasterboard:
Drill a 7/32"(5.5mm) hole into the drywall at each
pencil mark. Insert a drywall anchor into each hole.
Use a screwdriver or drill to insert the screws through
the lower catch wall bracket into the drywall anchor.
Drywall
Medium
anchor
screw
3b. For Drywall with Stud:
Drill a 5/64"(2mm) pilot hole into the stud at each
pencil mark (no anchor needed).
Use a screwdriver or drill to insert the screws through
the lower catch wall bracket into the stud.
Medium
screw
How To Install
Temp. B
(Catch Side)
3a. Drywall
7/32"
5.5mm
3a. Plasterboard
3b. Stud
5/64"
2.0mm
7/32"
5.5mm
9