Publicidad
INSTALLATION
STEP 1: Loosen the screws
on the head on both sides, use
another screw and nut to fix the
head on the middle hole of the
joint to make sure it will NOT be
adjusted over 180 degree. Then,
adjust the head to the position
you need. (Figure 1)
STEP 2: Tighten screws on both
sides of the bracket to secure the
light body. Ensure the light body
is stable without shaking. Loosen
the post screws with a wrench.
(Figure 2)
STEP 3: Connect fixture cables
as seen in wiring diagrams on
page 1. Cap all wire connections
and tuck wires carefully inside.
STEP 4: Install the fixture to the
pole and tighten post screws
with a wrench. (Figure 3)
PHOTCELL INSTALLATION
When the photocell function is
required, photocell should be
installed on the back of light.
COLOR TEMPERATURE SELECTION
Color temperature is selected by a push button
on top of the fixture.
Figure 1
Figure 3
2
Figure 2
Tighten
screws on
both sides
Tighten post
screws
Photocell
Socket
Light
Loosen post
screws
Publicidad
