IKIER K1 Pro MAX Guía Para Operar página 50

01. After opening the "Auxiliary positioning" function, click
02. Click the "Mark current position" button
03. Observe the error between the position of the mark and the cross
laser, if there is an error, proceed to the next step of calibration
04. Click the up, down, left, and right buttons to move the cross laser
light as close as possible to the mark position (error value <1mm),
and click "CONFIRM" after calibration
( A ) How to set "Auxiliary positioning" function in LightBurn:
01. Find "Window" in the top navigation bar, and enable "Console"
function in the drop-down menu
- 46 -
02. Select any custom button, right click mouse to pop up the
" "
button setting page, enter the name of the button in "Button Label",
enter [ESP501] under "Macro contents"
05
03. After clicking OK, a button with the corresponding
function will be generated
( A.1 ) How to use "Auxiliary positioning" function in LightBurn:
01. Click "Set Origin"
02. Click "Frame"
03. Click "Auxiliary Positioning"
04. Click "Start"
03
04
02
01
SETTING PART
01