Ibiza Light BIGPAR-27RGBW Manual De Instrucciones página 4

facturer or his service agent or a similar qualified person in order to avoid a hazard.
• The light source of this luminaire is not replaceable. When it reaches the end of its life time, the whole unit
must be discarded.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
FUSE REPLACEMENT
Locate and remove the unit's power cord. Once the cord has been removed located the fuse holder located in-
side the power socket. Insert a flat-head screw driver into the power socket and gently pry out the fuse holder.
Remove the bad fuse and replace with a new one.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact customer support
for further instructions. Continuing to use the unit may cause serious damage.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and able to support a weight of 10 times of the unit's weight.
LED DISPLAY
The LED display has 4 buttons: MENU / UP / DOWN / ENTER
MENU: Press to find an operation mode or to leave the current menu option.
UP: Press to scroll upwards through the list of options or set a higher value.
DOWN: Press to scroll downwards through the list of options or to set a lower value
ENTER: Press to activate a menu option or a selected value
DMX IN: Connect a 3-pin XLR connector from the DMX controller to this input
DMX OUT: Connect a 3-pin XLR connector from this output to the DMX input of
another DMX controlled unit
POWER IN: Connect the supplied mains lead to this input and the other end to an
appropriate wall outlet
POWER OUT: Connect a IEC power lead from this output to the POWER INPUT of the following BIGPAR. You can
connect up to 10 BIGPAR maximum.
DMX CHANNEL DESCRIPTION
No. Display
1 d001
8Ch
2
4Ch
Au01
------
Au08
3 Au09
Au10
So01
So02
St00
St01
4
------
St16
SP00
SP01
5
------
SP16
4
MANUAL - BIGPAR-27RGBW
Address code: 001-512
8 / 4 channel selection
Au01- Au08 Fixed color selection
Au09 Jump
Au10 Gradient
So01 Sound 1
So02 Sound 2
St00 No strobe
St01-St16 Strobe from slow to fast
SP00
SP01-SP16 Auto speed from slow to fast
©Copyright LOTRONIC 2022
Function Description
MENU UP DOWN ENTER
DMX512
INPUT
DMX512
OUTPUT