Publicidad
Idiomas disponibles
Idiomas disponibles
EN: ESPRESSO MAKER | Instruction Manual
WARNING: Steam from the steam wand is extremely hot and can scald.
NOTE: Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for
cleaning. Never wash your coffee machine accessories in a dishwasher.
CLEANING MINERAL DEPOSITS (DESCALING)
1. Disconnect the appliance from the mains supply, cut off power source.
2. Make sure the appliance has cooled down completely.
3. Remove the water tank and drip tray from the appliance.
4. Fill water tank with water and dissolved descales solution to the MAX level (the proportion of water and descale, refer to
the instruction of descales). Please use "household descales", instead of industrial descales.
5. Re-fit the water tank and drip tray to the appliance.
6. Place an empty container under the brewing head to gather the descaled hot boiled water.
7. Connect the appliance to the mains supply.
8. Press the power button and wait for the 1 cup button and 2 cup button to illuminate solidly.
9. Place the steam wand into a mug or jug and slowly turn the steam control knob until water dispenses.
10. Keep dispensing to fill the mug or jug, then empty when full.
11. Repeat the process until the water tank is empty.
12. Immediately refill the water tank with clean water and repeat the process to flush the system.
TROUBLE SHOOTING
Symptom
Cause
The metal parts
Descale is not recommended type. It may corrode the metal
in the tank have
parts in the tank.
rust.
There is much water in the drip tray.
The coffee maker is malfunction.
Water leaks
from the bottom
When the water tank is pulled up after use, it is normal that
of coffee maker.
there will be water left on the desk.
There is some coffee powder on filter edge.
The funnel is not installed properly or rotated to the right
Water leaks out
position
of outer side of
Milk foaming is finished just now or the steam is generated
filter.
just now, or the steam button is not reset due to too high
temperature.
10
Corrections
Use the descale recommended by
manufacturer.
Please clean the drip tray.
Please contact with the authorized
service facility for repairing.
As the water outlet at the bottom of
the water tank is a movable part and it
is Not leaking.
Get rid of them.
Install the funnel properly and ensure
the tunnel is in the right position.
Operating after cooling down.
EN: ESPRESSO MAKER | Instruction Manual
No clean correctly after cleaning mineral deposits.
Coffee powder is stored in a hot, wet place for a long time. The
Acid (vinegar)
coffee powder turns bad.
taste exists in
Espresso coffee.
Power outlet is not plugged well.
Coffee maker
cannot work
anymore.
The Milk Frothing indicator is not illuminated.
Steam cannot
The container is too big or the shape not fits.
froth.
You have used skimmed milk.
There is some dirt inside the steam nozzle.
Do not take apart the appliance by yourself if the cause of failure is not found,
contact the qualified servicing center.
Clean coffee maker per the content in
"before the first use" for several times.
Please use fresh coffee powder, or
store unused coffee powder in a cool,
dry place. After opening a package
of coffee powder, reseal it tightly and
store it in a refrigerator to maintain its
freshness.
Plug the power cord into a wall outlet
correctly, if the appliance still does
not work, please contact with the
authorized service facility for repairing.
Only after the Milk Frothing indicator
is illuminated, the steam can be used
to froth.
Use high and narrow container.
Use whole milk or half-skimmed milk.
Clean the steam nozzle immediately
after use every time with wet sponge.
11
Publicidad
